Description
This seal fits the Daihatsu Hijet Truck & Van S100, S110, S120, S130 (1994-1998). It keeps oil in and contaminants out at a rotating shaft, ending the leak at its source.
Special order from Japan - ships in 2 to 3 weeks
We order this part from Japan for your vehicle. Ground shipping only - expedited is not available, so please allow the full 2 to 3 week turnaround.
Vehicle Fitment & Compatibility
Confirm your chassis code against the table below before ordering.
100% Fitment Guarantee
Not sure about fit? Add your chassis/VIN number at checkout and we confirm it before we ship. If a part does not fit your Hijet, we exchange it or refund you in full.
Signs you need this seal
- An oil seep or drip at the shaft or cover
- Oil spots where you park
- Low oil between changes
- A previous seal that has hardened or cracked
Features & Function
- Keeps oil in and contaminants out at a rotating shaft
- Correct dimensions for a press-fit seal
- Restores a clean, leak-free seal surface
Installation Specifications
- Difficulty: Moderate.
- Estimated time: about 1 to 2 hours depending on location.
- Required tools: Seal driver or a correctly sized socket, a pry tool, and a jack and stands if at a hub.
Oiwa Garage Tech Note
"Inspect the shaft for a wear groove before fitting - a new seal on a grooved shaft will leak again. Lube the lip on install."
Frequently Asked Questions
Why did my old seal leak?
Usually age and heat, sometimes a worn shaft or a blocked breather building crankcase pressure - check the breather while you are there.
How do I confirm this fits my truck?
Match your chassis code (stamped on the VIN / data plate) to the fitment table above - S100, S110, S120, S130, 1994-1998.
Why does this ship in 2 to 3 weeks?
It is special-ordered from Japan for your vehicle (see the notice above). These ship ground only, with a 2 to 3 week minimum.
Fitment verified by the Kei truck specialists at Oiwa Garage · Listing updated June 2026.