Description
This 6 Piece Ignition Kit fits the Daihatsu Hijet Truck S100P, S110P (1994-1998) with the EF-GS (EFGS) engine. It refreshes the spark side with matched parts so the engine starts easily and runs smooth.
In Stock - ships from our California (USA) warehouse
Fast, reliable delivery - no overseas backorder wait.
Confirm your engine before you order
This part is engine-specific and fits the EF-GS (EFGS) engine only. Before ordering, find your VIN / data plate in the engine bay and confirm the line marked ENGINE reads EF-GS (EFGS). The photo below shows where to look.
Vehicle Fitment & Compatibility
The Hijet ran several engines in this era. Confirm your engine code on the VIN plate above, not just the chassis, against the table below.
100% Fitment Guarantee
Not sure about fit? Add your chassis/VIN number at checkout and we confirm it before we ship. If a part does not fit your Hijet, we exchange it or refund you in full.
Signs you need this 6 piece ignition kit
- Hard starting, especially when cold or damp
- A rough idle or a miss under load
- Tired plugs, cap, rotor, or leads of unknown age
- Loss of power and economy
Features & Function
- Matched ignition parts for a complete tune-up
- Restores a strong, consistent spark
- OEM-quality components for reliable starting
Installation Specifications
- Difficulty: Easy to moderate.
- Estimated time: about 45 minutes to 1.5 hours.
- Required tools: Spark plug socket, gap gauge, ratchet, extension, basic hand tools.
Oiwa Garage Tech Note
"Gap the plugs to spec, fit leads one at a time to keep the firing order, and put a dab of dielectric grease in the boots."
Frequently Asked Questions
Why does this engine take three ignition coils?
The EF is a three-cylinder engine, and this setup gives each cylinder its own coil. Replacing all three keeps the spark even instead of strong on one hole and weak on the next.
How often should ignition parts be replaced?
Spark plugs are due about every 30,000 km. The coils have no schedule of their own. Typical life is 130,000 to 190,000 km, or eight to twelve years, so check them whenever the plugs come out and replace any that run weak.
Do I need special tools to install this?
Ordinary hand tools handle it. Use a plug socket with the rubber insert so the porcelain survives, and put a little dielectric grease in each boot to keep water out.
Fitment verified by the Kei truck specialists at Oiwa Garage · Listing updated June 2026.