Description
This Output Shaft Rear Bearing Retainer fits the manual-transmission, 4WD Daihatsu Hijet S110, S130 (1994-1998). It holds the rear output shaft bearing in place and keeps the shaft correctly located in the case.
Special order from Japan - ships in 2 to 3 weeks
We order this part from Japan for your vehicle. Ground shipping only - expedited is not available, so please allow the full 2 to 3 week turnaround.
Vehicle Fitment & Compatibility
Confirm your chassis code against the table below before ordering.
100% Fitment Guarantee
Not sure about fit? Add your chassis/VIN number at checkout and we confirm it before we ship. If a part does not fit your Hijet, we exchange it or refund you in full.
Signs you need this output shaft rear bearing retainer
- Play or noise at the rear output shaft
- A worn or fatigued old retainer
- Servicing the output shaft or rear bearing
- Reassembling the transmission or transfer
Features & Function
- Locates and retains the rear output shaft bearing
- Keeps the output shaft correctly positioned in the case
- Correct bolt pattern and fit for the housing
- Direct replacement for a worn retainer
Installation Specifications
- Difficulty: Moderate.
- Estimated time: varies with the job.
- Required tools: Transmission service tools, sealant, and a torque wrench.
Oiwa Garage Tech Note
"Renew the retainer whenever you are in there for the output shaft bearing. A tired retainer lets the bearing walk and the shaft wander."
Frequently Asked Questions
What does this part actually do?
It retains the rear output shaft bearing and keeps the shaft located in the case. It is the retainer, not the bearing or the shaft.
Should I replace the bearing too?
If the bearing is worn, do both while the case is open.
Does it fit 2WD?
This is the 4WD manual-transmission application. Match your chassis and drivetrain before ordering.
Fitment verified by the Kei truck specialists at Oiwa Garage · Listing updated June 2026.

